those made of wood with fancy corner design?
No cool air conditioning then,
yet a fan and screen door seemed oh! so fine …
but squeaked open to welcome friends of mine…
and sometimes strangers,
or traveling salesmen trying hard to earn a dime…
used to latch the door but rarely used anytime?
And if the door spring broke,
the door flew wide… time out to fix and realign…
to nap right in the way, at the door’s front line;
pet cat thought the screen door to be
her scratching post
And oh! How Mom would whine!
I never learned; Slam! it went every time.
Old screen-door scenes beckon language memories
for which I often pine.
This stuff is what holds the screen in the groove of the window.
It is called spline.
Sometimes you can use the old spline from the window you are re-screening…..but for less than $5…go wild!
The real deal is the roller knife!
Having this tool on hand means that whenever you need to re-screen….you are good to go!
A roll of 25 ft. of screen for $20 bucks is enough to do LOTS of window….no MARVIN….don’t get any big ideas about the other windows!!!
So yesterday……Mr. S. and I spent a quick half hour replacing the pushed out screen on the deck door! This wasn’t our first time doing this….so it goes pretty quickly!
The door is easy to remove by loosening the screws that hold the wheels on the door track.
Since we didn’t want to crawl around on the floor, we covered the table with a sheet and put the screen on top.
It is a simple process to pull the old spline out of the track all the way around.
Then just take the old screening out.
Oh…don’t forget to take the handle off…because you need to get at the track underneath it.
Lay the new screen material on the window and cut it…..leaving a generous amount on the ends.
Then….start in one corner and push the spline into the track as you pull the screening tight.
This is where it is nice to have a “buddy”!
My job is pulling and stretching….Mr. S. is the pro with the spline tool
Don’t worry if you get a wrinkle….just pull the spline out and stretch tighter!
After the spline is pushed in all around the screen and there a NO wrinkles…..go back with a fancy tool like a spoon handle and push the spline in even tighter.
Cut the overlapping screening close to the edge with a straight edge razor blade.
The trick here….DON’T cut too close or you run the risk of the screen pulling out with any pressure on it…..(think MARVIN)!
Then it is just a matter of putting the handle back on….
Putting the door back in place!
I timed this process…..and from start to finish…including set up and clean up….it took 38 minutes!
Here is a YouTube video of the process by “an expert”….just in case I missed something!
So now we wait…..to see how long before our “bad Kitty” pushes this screen out!
But for now….we can “Shut the Screen Door!”
Have A Great Day!
Live From the Farm Hop It’s Overflowing Hope Studios